What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 02.07.2025 12:44
What does a fuse do?
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
This is where this question deviates from being a 'generic' question, and becomes more specific.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
So, the voltage could go up to 500 volts, and the fuse will not open up.
NASA sets new potential launch date for Ax-4 mission to ISS - SpaceNews
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Here is a simplified AC power diagram.
He then describes the function of a fuse.
nine
AMD CEO Su turns heads with comments at AI event - TheStreet
(Dc diagram shown, AC is similar).
Because the load is inductive, the current lags the voltage.(by a bit).
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
Kohler's $51M Arizona award terminated by Department of Energy - ABC15 Arizona
the problem then depends on "how fast does the fuse operate?".
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
2024–10–10[John johnson John Johnson ]
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
A fuse is a non-resetable over current circuit protector.
[old diagram got deleted by accident]
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
Why does Russia support Palestine in the Middle East conflict?
eight
The MOV will conduct when the voltage exceeds 50% of line voltage.
At least they know the answer if they wanted it.
But… the neutral is now “floating” because of the 1 ohm resistance.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
These are simplified answers to the original question, and does not change anything I wrote above.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
It seems Mohan does not understand the difference between a comment and an Answer.
How was cancer treatment different in the US and the UK?
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
but I think this circuit , shows a few more pieces.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
A circuit breaker is similar, but is resettable.
The third is lightning and “how it gets conducted into a home.”
I post the exact comment here.
2024–10–14 [Omar Gharbi Omar Gharbi ]
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Edit 2024–10.
This is 'the assistant's answer'
Upvotes:
An AC voltage/ current source, and an ac inductive load.
First Sentence:
He then asserts :
Barnstars:
One is “what exactly is in a ‘surge protector’ ? ”
2024–10–16 [ OO OLAOYE OYEBODE ]
so, what happens?
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
What is lightning?
but this device (an Inductor) … impedes the rapid changes in the current.
For this case there are devices called Metal oxide varistors (MOV).
There are three different concepts here that are getting confused.
He then describes Rainy Season and Lightning.
There are two important concepts here.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
The other is “what does a “fuse” do?”
This is where the MOV conducts again, and dissipated the energy.
In schematic diagrams this is the symbol for a fuse:
At one ohm, the resistor has a maximum of 1 watt power.
One
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
The bolt then partially travels down the line to your home.
But it can get overloaded, and no longer works.
[image of Common-mode choke]
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
what exactly is a ‘surge’ protector?
This one hit behind the barn.
This device then solves the entire problem.
These devices are installed between the “hot” and “neutral” and protective ground.
a photo is worth a thousand words.
Now when you have a certain ac resistance, then a current flows in a loop.
It also is a device that limits the change in current flow.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.